TM 5-3990-263-13&P
0055
INSTALLATION - Continued
15.
Install four screws (Figure 7, Item 14) and two double brackets (Figure 7, Item 15) on two tubes (Figure 7,
Items 16 and 17) and winch frame (Figure 7, Item 18).
CAUTION
BAP hydraulic hoses must be installed through restraining bracket welded onto winch frame.
Failure to properly install hydraulic hoses could result it damage to hoses during BAP
operation.
16.
Install tube nut (Figure 7, Item 10) on hose connector (Figure 7, Item 11). Install tube nut (Figure 7, Item 12)
on hose connector (Figure 7, Item 13).
17.
Install two O-rings (Figure 8, Item 9) on male quick-disconnect coupling half (Figure 8, Item 1) and female
quick-disconnect coupling half (Figure 8, Item 3).
2
4
5
6
1
3
9
9
7
8
Figure 8.
Winch Quick Disconnect Installation.
18.
Install female quick-disconnect coupling half (Figure 8, Item 3) on hose (Figure 8, Item 8).
19.
Install male quick-disconnect coupling half (Figure 8, Item 1) on hose (Figure 8, Item 7).
20.
Install backup ring (Figure 8, Item 5) and preformed packing (Figure 8, Item 6) in female quick-disconnect
coupling half (Figure 8, Item 3).
21.
Install female quick-disconnect coupling half (Figure 8, Item 3) on dummy male quick-disconnect coupling half
(Figure 8, Item 4).
22.
Install male quick-disconnect coupling half (Figure 8, Item 1) on dummy female quick-disconnect coupling half
(Figure 8, Item 2).
END OF TASK
FOLLOW-ON MAINTENANCE
1.
Load the BAP on the CBT. (WP 0005)
2.
Briefly operate BAP winch and check for leaks.
03/15/2011Rel(1.8)root(maintwp)wpno(M04049)
