TM 5-3990-263-13&P
FIELD MAINTENANCE
WINCH ASSEMBLY REPLACEMENT
INITIAL SETUP:
Personnel Required
Tools and Special Tools
(2)
Pan, Drain, 5-Gallon (WP 0078, Table 2, Item 1)
Lifting Device, Minimum Capacity 350 lb (158.9 kg)
Tool Kit, General Mechanics: Automotive
References
(WP 0078, Table 2, Item 2)
Parts Manual (WP
0073, Figure 12)
Parts Manual (WP
0073, Figure 14)
Materials/Parts
Parts Manual (WP
0073, Figure 15)
Cap and Plug Set (WP 0081, Table 1, Item 4)
Parts Manual (WP
0073, Figure 16)
Gloves, Protective (WP 0081, Table 1, Item 8)
Parts Manual (WP
0073, Figure 17)
Goggles, Safety (WP 0081, Table 1, Item 9)
Parts Manual (WP
0073, Figure 19)
Lubricating Oil (WP 0081, Table 1, Item 17, 18, 19,
20)
Rag (WP 0081, Table 1, Item 21)
Packing, Preformed
Equipment Condition
(WP 0082, Table 1, Item 17) Qty: 2
Load removed from the BAP. (WP 0008)
Cotter Pin (WP 0082, Table 1, Item 34) Qty: 4
BAP unloaded from the CBT. (WP 0006)
Lockwasher (WP 0082, Table 1, Item 44) Qty: 8
Lockwasher (WP 0082, Table 1, Item 46) Qty: 4
REMOVAL
WARNING
If winch cable has to be cut to remove winch assembly, wrap cut end of cable in tape and
secure loose end of cable to prevent it from swinging free during winch assembly removal.
Failure to comply may result in serious injury or death to personnel.
WARNING
The winch assembly without cable installed weighs approximately 350 pounds (158.9 kg).
Winch must be secured by a suitable lifting device before removing or installing mounting
hardware. Failure to comply may result in serious injury or death to personnel.
CAUTION
To prevent contamination of hydraulic system, cap and/or plug hydraulic lines and ports after
disconnecting lines.
0058-1
03/15/2011Rel(1.8)root(maintwp)wpno(M04051)