TM 5-3990-263-13&P
FIELD MAINTENANCE
REAR BUMPER ASSEMBLY REPLACEMENT
INITIAL SETUP:
Equipment Condition
Tools and Special Tools
Tool Kit, General Mechanics: Automotive
Load removed from the BAP. (WP 0008)
(WP 0078, Table 2, Item 2)
BAP unloaded from the CBT. (WP 0006)
Materials/Parts
Cotter Pin (WP 0082, Table 1, Item 36)
References
Parts Manual (WP 0073, Figure 7)
REMOVAL
NOTE
This task is for older model BAPs only, new model BAPs not equipped with rear bumper
assembly. Repair and/or replacement is at the discretion of the Unit Commander.
This task can be used for the road-side, curb-side, or middle roller bumpers. The middle
roller bumpers are shown.
1.
Remove cotter pin (Figure 1, Item 1) from bumper shaft (Figure 1, Item 2). Discard cotter pin.
1
3
2
4
Figure 1. Rear Bumper Assembly Removal.
2.
Remove bumper shaft (Figure 1, Item 2) and three roller bumpers (Figure 1, Item 3) from BAP frame (Figure
1, Item 4).
03/15/2011Rel(1.8)root(maintwp)wpno(M04043)