TM 5-3990-263-13&P
0055
REMOVAL - Continued
NOTE
Before removal, mark one end of the check valve, straight adapter, and tube nut. The check
valve must be installed the same way it is removed.
15.
Remove tube nut (Figure 3, Item 44) and tube (Figure 3, Item 45) from straight adapter (Figure 3, Item 46).
Remove straight adapter (Figure 3, Item 46) from check valve (Figure 3, Item 47). Remove check valve (Figure
3, Item 47) from straight adapter (Figure 3, Item 48). Remove tube nut (Figure 3, Item 49) from straight adapter
(Figure 3, Item 48).
16.
Remove tube nut (Figure 3, Item 50) and tube (Figure 3, Item 51) from elbow (Figure 3, Item 52) on side of
winch motor (Figure 3, Item 53).
17.
Remove tube nut (Figure 3, Item 54) and tube (Figure 3, Item 55) from elbow (Figure 3, Item 56) on top of
winch motor (Figure 3, Item 53). Loosen captive nut (Figure 3, Item 57) and remove elbow (Figure 3, Item 56)
and preformed packing (Figure 3, Item 58) from winch motor (Figure 3, Item 53). Discard preformed packing.
18.
Remove tube nut (Figure 3, Item 59) and tube (Figure 3, Item 60) from elbow (Figure 3, Item 61) on bottom of
winch motor (Figure 3, Item 53). Loosen captive nut (Figure 3, Item 62) and remove elbow (Figure 3, Item 61)
and preformed packing (Figure 3, Item 63) from winch motor (Figure 3, Item 53). Discard preformed packing.
NOTE
Note where dummy coupling halves were removed.
19.
Remove two screws (Figure 4, Item 64), lockwashers (Figure 4, Item 65), and dummy quick-disconnect
coupling halves (Figure 4, Items 2 and 4) from mounting bracket (Figure 4, Item 66). Discard lockwashers.
0055-5
03/15/2011Rel(1.8)root(maintwp)wpno(M04049)