TM 5-3990-263-13&P
FIELD MAINTENANCE
REAR GUIDE REPAIR
INITIAL SETUP:
References (cont.)
Tools and Special Tools
Tool Kit, General Mechanics: Automotive
(WP 0078, Table 2, Item 2)
Materials/Parts
Equipment Condition
Locknut (WP 0082, Table 1, Item 24) Qty: 11
Load removed from the BAP. (WP 0008)
Lockwasher (WP 0082, Table 1, Item 50) Qty: 5
BAP removed from the CBT. (WP 0006)
Cotter Pin (WP 0082, Table 1, Item 38)
Locknut (WP 0082, Table 1, Item 25)
Spring Pin (WP 0082, Table 1, Item 28)
References
Parts Manual (WP 0073, Figure 5)
REMOVAL
WARNING
Support BAP rear guide in place when removing pivot pin. Failure to comply may result in
serious injury or death to personnel.
NOTE
Rear guide latch handle must be in locked position and rear guide in full open position
before performing task.
This task can be used for either curb-side or road-side rear guide. Road side is shown.
1.
Remove 11 screws (Figure 1, Item 1) and locknuts (Figure 1, Item 2) from rear guide pad (Figure 1, Item 3)
and rear guide (Figure 1, Item 4). Discard locknuts.
0045-1
03/15/2011Rel(1.8)root(maintwp)wpno(M04040)